Flexlink YOUTILIZE Manual de usuario descargar pdf (Pagina 122)

Providing production

efficiency

Page 122 of 125

• SI

limit_slide rail idler

Lim

LimLimLim

)f(X YSI ===

The next inspection point is over writing all these values with (hopefully) even more accurate values.

Database Requirements

Time to next service uses data from two tables in the database – ServiceLogs (max size

approximately 200 bytes per motor) and EquipmentMeasurements (max size approximately 150

bytes per motor per measurement). Each motor utilizes one ServiceLogs record as an accumulator,

so this tables’ size will never amount to much. Each motor power change is recorded in

EquipmentMeasurements, so for a dumb motor this will be very few records, for a smart motor

under constantly varying load this could become quite high.

At a large installation with more than 100 motors, and also full Production Montioring the database

can grow to as much as 6GB after 3 months. Such installations automatically include a full MSSQL

license, which has a maximum data size of 524 petabytes, so the only real limitation is the size of the

drive used to contain the database. The free MSSQL Express version installed with Serice Level

Monitoring has a limitation of 4GB of data, should more be required, then a full MSSQL license must

be purchased. The software contains a cleanup routine that removes all data over 6 months of age

and this does not have any effect on Time to next service which needs the ServiceLogs record and

the last EquipmentMeasurements record for each specific motor only. So for pure Service Level

Monitoring, the database size should not be a problem.

1 2 ... 117 118 119 120 121 122 123 124 125

Sin comentarios

Flexlink YOUTILIZE Manual de usuario Pagina 122